Hello Everyone.
We recently had a power failure and afterwards when our p2000 came back online, one of the controllers seems to have failed. The MAC and IP both show as all 0 and it will not take any settings push to it through ssh. The commands return as successful, but there is no actual change.
We went through one of our supplier for a refurbished controller and slipped it in. It had a higher firmware version and the upgrading of the other one appeared to go well. However the expander controller code version appears to be different between them despite a match.
The logs are now continuously being spammed every 5 minutes with the error seen in the second picture
( The firmware version is not compatible, HP SPS-CHASSIS 2028)
When I restart the new controller in A, it seems like the data failover is working when I restart controller A. Controller statistics shows new data reading and writing on B when this occurs.
I'm hoping I can get a little more insight into these behaviors as i'm fairly certain I have exhausted my searching attempts.
Thank you.
