Hi, I was change the connector FC to iSCSI.
The command "show ports"
Ports - A1
Media - FC(-)
Target ID -207000c0ff298f73
Status - Disconnected
Speed - Auto
Health - Fault
Reason - The installed SFP does not match the configured protocol of this port.
- Validate the SFP is supported, and configure the protocol via the set host-port-mode command.
The command "set iscsi-parameters" was not recognized
How can I correct this situation?
These are equipament information:
System Information
Midplane Serial Number: 00C0FF298F73
Product ID: MSA 1040 SAN
Controllers
Serial Number: 7CE735M246
Hardware Version: 3.1
Controller A Versions
Storage Controller CPU Type: Gladden 1300MHz
Bundle Version: GL220P009
Base Bundle Version: G22x
FRU
Name: RAID_IOM
Description: SPS-CONTROLLER FC MSA 1040
Part Number: 758366-001