Looks like IP address got back to factory default. Please find below information,
"
Each controller has the following factory-default IP settings:
• DHCP: enabled
• Controller A IP address: 10.0.0.2
• Controller B IP address: 10.0.0.3
• IP subnet mask: 255.255.255.0
• Gateway IP address: 10.0.0.1
When DHCP is enabled, the following initial values are set and remain set until the system is able to contact a DHCP server for new addresses.
• Controller A IP address: 10.0.0.2
• Controller B IP address: 10.0.0.3
• IP subnet mask: 255.255.255.0
• Gateway IP address: 0.0.0.0
To switch a controller from DHCP addressing to static addressing, you must set the IP address, netmask, and gateway values.
"
You can verify the IP address from Serial access as well.
You can refer CLI guides to get necessary commands.
Hope this helps!
Regards
Subhajit
If you feel this was helpful please click the KUDOS! thumb below!
***********************************************************************************
