After going through the CLI, I found that the MSA1000 controller does not support Host Mode. At this point, I cannot find anyway to access the Array/Logical Drive that is created. Now that I have the Array and Logical Drive setup, how do I access this so I can save files there? I can't find anything in the docs beyond this point. Thank you in advance for help!
Here is the info from the CLI:
=> ctrl ch=SAN1-Right show
MSA1000 in SAN1-Right
Bus Interface: Fibre Channel
WWN: 500805F30001F730
Serial Number: P56350B9IN40IZ
Chassis Serial Number: 9J25JN71F56V
Chassis Name: SAN1-Right
RAID 6 (ADG) Status: Enabled
SSP State: Disabled
Controller Status: OK
Chassis Slot: 1
Hardware Revision: Rev A
Firmware Version: 1.16
Cache Board Present: True
Cache Status: Temporarily Disabled
Total Cache Size: 128 MB
No-Battery Write Cache: Disabled
Chassis Slot 1 Battery Info
Cache Backup Power Source: Batteries
Battery/Capacitor Count: 1
Battery/Capacitor Status: Failed (Replace Batteries)
Host Bus Adapter Slot: 1
SATA NCQ Supported: False
=> ctrl ch=SAN1-Right show ssp
MSA1000 in SAN1-Right
Adapter ID: 21000024FF022245
connectionname: Data
Location: Local
Status: Online