Can you please provide the GUI screenshot of the Pool usage?
You need to provide size information at the Pool level, Disk Group leve to get the idea.
# show pools
# show disk-groups
# show snapshot-space
As per SMU guide "If you try to disable overcommitment and the total space allocated to thin-provisioned volumes exceeds the physical capacity of their pool, an error will state that there is insufficient free disk space to complete the operation and
overcommitment will remain enabled. If your system has a replication set, the pool might be unexpectedly overcommitted
because of the size of the internal snapshots of the replication set."
There is one known issue,
Issue: When downloading CSV data from the "Pools" table, the fifth column is incorrectly labeled as "Allocated Size", when it should be "Available Size".
Workaround: After downloading CSV data from the Pools table, change the label of the fifth column from "Allocated Size" to "Available Size".
You can try restarting both management controllers.
You can try by updating Controller firmware to latest version VL270R001-01
Hope this helps!
Regards
Subhajit
I am an HPE employee
If you feel this was helpful please click the KUDOS! thumb below!
***********************************************************************************