Hello Matheus Giovanni,
The MSA2040 is provisioned (creating volumes and mapping to host) via webGUI or CLI access to its management port.
There are 2x management ports on MSA2040 SAN, one on each controller.
If there is a new array and is not yet configured, user could setup the laptop/system in array default newtork space, connect to mgmt port via cross-over cable and configure/change the network settings.
Array has iSCSI host ports (based on controller type) to connect and map the LUN(s) to hosts CNA PCI cards.
User will need to assign host reachable IP addresses to MSA iSCSI ports and configure additional sessions (additional physical paths) from host iSCSI template.
**Jumbo frame must be enabled on all or none (array host port settings, switch and HBA).
The LUN could be mapped to desktop if iSCSI template is available on installed OS and desktop has compatible CNA card.
For basic connectivity, please refer :
https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c03792354
For mgmt port configuration, provisioing etc:
https://support.hpe.com/hpsc/doc/public/display?docId=c04220794
It would be good idea to reach to HPE support for configuration assistance on best effort basis.
I am HPE Employee
If it resolves the issue, please consider marking it as an Accepted Solution.
The comments in this post are my own and do not represent an official reply from the company. No warranty or guarantees of any kind are expressed in my reply.